I have an old amp which is beginning to show wear and scratches on its RCA ports. However, alcohol, water, and a simple cloth dont work and cannot remove the grime on the ports. What is the best substance to use to clean the ports without damaging the amp?
7
-
1Looks just like a bit scratched surface and doesn't seem to cause any issues. Why is it so important for you to eliminate those marks?– Eugene SCommented Mar 31, 2013 at 14:52
-
The amp has some noise... I took it apart and cleaned the circut boards but I still get noise at high volume.. so I'm thinking it might be the plugs.– user7343Commented Mar 31, 2013 at 15:21
-
Can you please specify the noise? Was it hum, hiss or buzz?– Eugene SCommented Mar 31, 2013 at 15:27
-
Seems like a hum, but I only hear it when its turned up to high volume levels when connected to a quiet device such as an iPod. When watching a movie, etc. I dont hear it since the dial is not turned as high up. It might actually be my cables (they arent that good) but I dont know.– user7343Commented Mar 31, 2013 at 16:11
-
With volume set to a normal listening level, how close to the speaker must you be to hear the noise? If the answer is a few feet (or less), the noise level is likely normal. If you can hear it from the listening position (or, especially if it intrudes upon the listening experience), this is a problem that warrants further investigation.– Eugene SCommented Mar 31, 2013 at 16:17
|
Show 2 more comments
1 Answer
I've always found a contact cleaner, such as plastic-safe DeoxIT, works wonders for these types of connections. I normally spritz some on the plug itself, then work the plug in and out of the port a few times, spritz again, remove excess, plug in and go.
