Skip to main content
2 votes
Accepted

How to simulate distance with lavalier mic in post-processing

Contrary to some of the other answers, I wouldn't start with removing high frequencies with EQ. I would instead start with removing low frequencies. If the lav mics are cardioid, then they will ...
Todd Wilcox's user avatar
  • 2,290
2 votes

Drums sound great on Mixer but Awful on DAW

Do not use an XLR cable from mixer to audio interface. Use a balanced TRS cable at least on the mixer side, and XLR or TRS on the mixer. This is the connection you are complaining about and you don'...
user107063's user avatar
2 votes

How to EQ vocals to sound airy but not harsh? (Example included)

if my sounds seem to be to harsh, I use smooth operator(vst).It's kind of a dynamic eq + comp. But if you have a higher budget you might want to check out soothe 2 or gullfoss or I think Ozones ...
DR4GON8IT3music's user avatar
2 votes

Replacing old mic with new mic (Rode Wireless Pro) on Mackie mixer - volume is incredibly low on Rode?

I am surprised you are hearing anything at all. The inputs you have here are balanced line inputs. The 3.5mm output of the wireless is an unbalanced output with identical signals left and right. With ...
user107063's user avatar
1 vote
Accepted

Is mixing the irreversible addition of track signals

I think the definition of track and channel is a little looser than what you are describing here, and in the audio world largely comes from the 'tracks' found on a recording medium and 'channels' of a ...
OwenM's user avatar
  • 226
1 vote

Sending line-level signal to two devices

I suggest you put some resistors here just to be on the safe side, like this: L_IN1<------|2k|------+------<L_OUT L_IN2<------|2k|------+ R_IN1<------|2k|------+------<R_OUT R_IN2<--...
flohack's user avatar
  • 111
1 vote

How to simulate distance with lavalier mic in post-processing

You can add a bit of reverb, take a bit of the high frequencies. You want the "remote" speaker to end up with a similar volume and comprehensibility as the "local" speaker, but ...
user107063's user avatar
1 vote

How to simulate distance with lavalier mic in post-processing

Wild guesses: EQ to remove some of higher frequencys. Add reverb to taste.
ghellquist's user avatar
  • 1,624
1 vote

How to add a 4 headphone amplifier to an audio interface (High imp headphones)

The input on the HP4 appears to be a line input, so monitor output would be preferable unless you specifically need something that only the headphone output can do.
AJ Henderson's user avatar
  • 8,182

Only top scored, non community-wiki answers of a minimum length are eligible