Stack Exchange Network

Stack Exchange network consists of 175 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.

Visit Stack Exchange

Questions tagged [subwoofer]

The tag has no usage guidance.

0
votes
2answers
46 views

Isolate a subwoofer from the floor below

So, I live in a two story house, and I have a subwoofer. any recomendations to isolate my subwoofer from my floor to keep the room below me relatively quiet?
3
votes
1answer
327 views

Why do subwoofers have different frequency ranges?

I am looking to buy a subwoofer. My previous subwoofer had a frequency range of 25hz - 1700 Hz. The one I am looking at now has a frequency range of 20 - 125 Hz. I am wondering why there is such a ...
0
votes
1answer
393 views

Are 4 inch subwoofer any good?

I'm planning to use a 4 inch 4 ohm 25W local subwoofer from amazon for my diy project. This one - https://www.amazon.in/Soumik-Electricals-Subwoofer-4-Inch/dp/B077BFKZZV/ref=mp_s_a_1_3?ie=UTF8&qid=...
0
votes
2answers
37 views

Sound uneven after installing more powerful woofer

Hey guys so I think I messed up :( I have 4 Behringer B212XL speakers. The woofers in the speakers had blown so I decided to upgrade them to more powerful woofers. The out of box woofers were 200W ...
5
votes
2answers
5k views

How to connect Powered Subwoofer to Mixer?

I have two Alto TS210 Powered Active Speakers connected to Yamaha MG06 Mixer, which is then connected to my laptop via Stereo Y-Cable. That setup is working fine, however, I would like to now add a ...
1
vote
1answer
689 views

How to dampen subwoofer?

I'm running the Logitech Z313 speakers and the subwoofers are being too effective for my neighbours, even when the volume is at below half. How can I dampen the effect from the subwoofer so it travels ...
0
votes
1answer
3k views

Wiring 2x subwoofers down to 1 or 0.5 ohm on a 2 ohm verified amplifier? [closed]

This is strictly a hypothetical question. I have a 2600W peak monoblock amplifier for my car, which is rated at 1000W at 2 ohm. I am currently wiring my subwoofers to the amplifier like this: What ...
0
votes
2answers
2k views

For optimal 3-way sound: should passive speakers be connected to my amplifier/mixer, or to the crossover of an active subwoofer?

Currently I have 2 passive speakers connected in stereo to an amplifier (with a mixer). I am looking to introduce an active subwoofer into the system in order to produce more accurate 3-way sound in ...
1
vote
1answer
729 views

Why does my subwoofer makes popping noise after (only after) playing for 10 to 20 minutes? [closed]

I have a 5.1 audio system set up. Recently I notice the subwoofer will make popping noise after playing for 10 to 20 minutes. It can be solved by turning off the the subwoofer, unplug the audio cable. ...
1
vote
1answer
243 views

Are there different versions of the Adam Sub8 Subwoofer?

I own a pair of the lovely Adam A7X. Now I'd like to extend its lower range capabilities by buying an Adam Sub8 on eBay. The seller states that it is from 2008. But now I've noticed that the back ...
5
votes
1answer
59 views

Appropriate Subwoofer Coverage

I'm running live sound for an event that takes place in a 100'x100' building. The walls are pretty thin, floors are concrete, ceiling is arched and probably 25-35' at highest point. I will probably ...