0

I am pretty new to this, just trying to get everything to work.

I have an Onkyo TX-8050 receiver hooked up to a set of Paradigm Atom V7 speakers. I am playing from a turntable Audio Technical AT-LP60 connected through phono.

When I turn up the volume, the sound it is producing is what I would describe as "shaky", or trembling (not distortion). When I turn up the volume, it is no where near "loud". It happens only when hooked up to my turntable, I have separately tested the turntable with another speaker, and the stereo with another audio source (to even louder volume), and they were both fine.

What could be the possible cause of this? I have already swapped in another turn table, but the problem is still there. I am suspecting a setup/settings issue, but have no clue what it might be. Any help is appreciated. Thanks!

closed as off-topic by Tetsujin, Rory Alsop Oct 30 '15 at 11:19

This question appears to be off-topic. The users who voted to close gave this specific reason:

  • "Questions that are related to consumer audio consumption (such as audiophile or home theater) are off-topic. For more information, see the meta post on Non-Production Questions." – Tetsujin, Rory Alsop
If this question can be reworded to fit the rules in the help center, please edit the question.

  • How about a recording of the shaky sound? – Andy aka Oct 15 '15 at 22:39
  • Thanks for the reply, I found the problem! My table was vibrating from the speakers, causing the turntable to vibrate and produce the "shaky" sound. – gptt916 Oct 15 '15 at 23:41
1

I have found out the problem, I will share this with anyone that may run into this in the future. It was a simple problem yet I could not notice it at first. The table I had my turntable on was vibrating from the speakers, thus causing the stylus to shake all over the record.

  • 1
    We had exactly the same problem with our stereo setup in the studio - a temporary low quality turntable placed too close to the speakers - and it was not only mechanically induced resonance (I solved that with foam), but also the bass waves them selves that caused the cheap plastic casing to resonate. Get a heavy turntable with good mechanical isolation/suspension – Michael Hansen Buur Oct 16 '15 at 8:00

Not the answer you're looking for? Browse other questions tagged or ask your own question.