I have been trying to record folding clothes with a zoom H2 and obviously I get more noise than the signal and then when I try to eq the noise the signal also get very weak. What would be a better microphone to record this at home?
Sound Design Stack Exchange is a question and answer site for sound engineers, producers, editors, and enthusiasts. It only takes a minute to sign up.Sign up to join this community
Are you trying to do this as foley? If so, I would say to stop "folding" the clothes and do more handling noise. Rub the fabrics together, snap them, get any kind of louder sounds you can out of them. These will be far more useful to you as a source of foley, as you can always decrease their volume to have them better fit what you're mixing them in to.
I'm assuming this is for sound to picture? Because chances are that your folding sounds in your mix will also be pretty soft compared to the rest of the sounds and so you don't need to crank up the gain. If you only have a Zoom H2 at hand then you can easily make that work for you.
Also, if you want to have the sound of folding cloths, then chances are you do not need the actual sound of folding cloths, but pick louder fabric and "perform" them louder, then bring it down in your mix later. As I'm typing this, I see @Shaun just wrote the same thing... haha.
You can also use a parametric EQ to hone in the frequency of your noise. I know my mic/recorder setup usually gets that pre-amp noise around 10KhZ.
Hope this helps.
Here's a previous SSD thread that may help you a bit:
In all honesty, this is a good example of Good Mic + Good Mic Preamp + Good A/D Comverters (+ Good Skill) = the sound you're looking for. There truly is no substitution for a good signal chain.
Early on in my recording days I had a crappy Yamaha 16 channel mixing board and an Audio-Technica 4033 mic. After a while I purchased an Avalon 2022 mic pre and Neumann U67 mic. After that Eureka moment of "ohhhhhhhhhh.....so THIS is what it should sound like" I never went back to cheap gear again.
Now, we all record with the best possible gear we can get our hands on and an unfortunate reality of our line of work is that we can never have enough variety of microphones, mic preamps, etc. I would love to own one of everything but my wallet disagrees.
The louder the sound source the less "work" your mic and pre have to do. That translates to less electrical noise in your signal chain.