0

This question already has an answer here:

I have recently purchased a Behringer Xenyx 802 mixer. It is a analog mixer that uses RCA to 3.5mm connections to my iMac's line in port.

I am using logic to record single tracks at a time, but I would like to record multiple tracks at once. For instance, Guitar and Bass.

When I make two audio tracks and select input one, and input for each of the tracks, both instruments play on both tracks at the same time.

I am wondering if it is possible to assign each instrument to its own corresponding track.

marked as duplicate by Christian van Caine, JoshP Oct 19 '14 at 13:21

This question has been asked before and already has an answer. If those answers do not fully address your question, please ask a new question.

1

You need a line per channel. You have 2 lines, so you can only record two channels at a time through the mixer. You would need to assign them to the left and right channels of your output respectively by using the pan knobs.

  • Hmmm... that sounds like it would work but how would i get the channels into my computer since it only has one line input – user2368535 Oct 16 '14 at 22:49
  • Would i need a audio interface? – user2368535 Oct 16 '14 at 22:50
  • 1
    If you have a stereo line input, you could use that. The best quality would be to get an ASIO interface, but you should probably be able to get stereo input through a line input if you have that. – AJ Henderson Oct 17 '14 at 0:01

Not the answer you're looking for? Browse other questions tagged or ask your own question.