So i shot a short film where one scene happens in the boot of a car. The actor was directed through a iphone earpiece but unfortunately the level was set too high, it bleeds into the recording quite obviously at times. Ive tried pretty much everything i can think of to get it out, eqs, izotope, x-noise etc but i never get it right. ive got the original directors take and tried to match it excactly to the bleed, even re-recorded it through the same earpiece and tried to use phase cancellation, but it just doesnt go away, not even dent a little bit (maybe im not doing it right) Any ideas on what i could do? and since i dont use phase cancellation a whole lot, i might be doing something wrong..