Take the 2-minute tour ×
Sound Design Stack Exchange is a question and answer site for sound engineers, producers, editors, and enthusiasts. It's 100% free, no registration required.

Hi there,

I have done some research into my question but am still finding it hard to grasp an overall understanding of the difference between dBFS and dBu for leveling when it comes to final mix and standards for cinematic release. I know that each country is different. In South Africa, the spec for cinematic release is -2dBFS. We use the -18dB as our 0 on the peak meter but what is dBFS? Does it mean theat we peak at -2dBFS on the peak meter with a dynamic range of about 11dB?

I hope this isn't to confusing. Thanks.

share|improve this question
    
+1, I was LITERALLY just looking into this myself this minute! –  Skarik Nov 11 '11 at 11:05
add comment

2 Answers 2

Ok the first and most important thing to realise is that dB is a relative scale, it is essentially a ratio but because we deal with such large ratios it is also a logarithmic scale to make the numbers more manageable.

So to use dB as a measurement we need to specify a reference point. For dBu, the reference - 0dBu is 0.775volt. Now dBu is a measurement of voltage or signal level. For dBfs, the fs stands for full scale and is only relevant in digital settings and so 0dBfs is when all the bits are a 1, ie it can't get any higher.

To relate the dBu and dBfs scales you need to establish what your headroom figure is going to be and like all good standards we have more than one. Some manufacturers set -20dBfs as 0dBu, the standard here in the Uk is -18dBfs is 0dBu. So you have to know what your metering has been set to, to be able to equate dBu ad dBfs.

Hope that helps,

Mike.

share|improve this answer
    
Great answer Mike! –  Colin Hunter Nov 11 '11 at 22:06
add comment

Quick question on this topic-

if -20 dBFS = +4 dBU, does that mean that you can only record up to +24 dBu before your digital signal clips?

I know that is only a reference level so probably not, but is there a dBu maximum where clipping will occur?

Thanks.

share|improve this answer
1  
no. this is just a reference point relating between two scales (digital and electrical respectively). –  Shaun Farley Mar 28 '12 at 16:46
    
ok but when recording to tape was there some sort of measurement as to when that would occur? –  Max H. Mar 28 '12 at 20:42
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.